|
Senninger offers a variety of components to help provide solutions to many different irrigation installation needs.
Providing Solutions
Riser Adapter
Senninger Irrigation’s RISER ADAPTER is now available in a new versatile model.
The new QUICK-CONNECT design has a press-fit inlet and outlet.
This makes it easy to assemble and disassemble to store the various components – an ideal feature for temporary and portable systems. The riser adapter allows sprinklers and spray nozzles with 1/2" M NPT base connection to be mounted securely onto 1/2" PVC, 3/4" PVC, or 5/16" steel rod stakes and connected to low pressure Polyethylene laterals. This makes irrigating easier in hard-to-reach places.
• Three models: Quick-connect with press-fit connection for 0.270" PE tubing only; Barb connections for 0.270" and 0.345" PE tubing
• No gluing or fusing required
• Available as individual components or as an assembly
• Quick-Connect Assembly includes: One Riser Adapter, two press-fit barbs, 3 ft. [0.9 m] PE tubing (0.270"), one bushing
• Outlet 1/2" F NPT
|
 Drain Stop Plus
Senninger’s Drain Stop Plus is specifically designed for overhead irrigation to prevent draining from applicators when the system is shut down. This protects plants beneath applicators from damage and over-watering. The Drain Stop Plus allows lines to remain full to help expedite system start-uptime and maximize initial zone coverage. Its unique three-in-one dial design (open, check, and closed) provides additional versatility. It has an easy-clean feature allowing the device to remain in place. A simple twist of releases the bonnet for debris removal.
• Two models available: 1/2” M NPT inlet x 1/2” F NPT outlet and 3/4” barb inlet x 1/2" F NPT outlet
• Can be used with any 1/2" M connection applicator
• Flow: 0.25 to 5 gpm or 57 - 1136 L/hr
• Minimum opening pressure: 13.5 psi or 0.93 bar
• Minimum closing pressure: 3.5 psi or 0.24 bar
• Maximum operating pressure: 50 psi or 3.45 bar
|
|
Nursery Wire Adapter
Senninger’s Nursery Wire Adapter provides easy installation for Misters or other non-impact applicators directly onto wire mesh plant beds. The two-piece device locks into the corner of the wire. Flexible tubing attaches to the lower barb then connects to the polyethylene lateral. The top portion allows use of either a 1/2 or 3/4” PVC riser.
• Fits up to 10-gauge wire
• Minimum 1-inch mesh
• Specifications: 1/2” slip ID 3/4” M slip OD
• Barb fits 0.345” tubing
|
|
Drop Adapter
The Senninger Drop Adapter offers simple, fast and economical installation of drops. It is available as individual components or as an assembly. The Assembly includes two Super Barb Connectors, one 1/2” slip x NPT Connector, 12 inches of 0.345” tubing, 12 inches of 1/2” PVC. It is available with a 1/2” F slip, 3/4” M slip, or 1/2” M NPT outlet connection.
|
|
 Tubing
Senninger also offers flexible tubing in 0.125” for Spray Stakes, 0.270” and 0.345” for Riser Adapters and Drop Adapter Assemblies.
|
|
 Punch Tools
Senninger's punch tools are ideal for making precise holes in tubing to install barbs or emitters. Models available for 0.125", 0.270", and 0.345".
|
|
